C.3 Running the examples

Before you can run the program on the Integrator, you must:

1.Start Multi-ICE and configure it using Auto-Configure.

2.Use a cross-over cable to connect Serial Port A of the Integrator/AP to a COM: port on your workstation.

3.Use a terminal emulator to monitor the COM: port for diagnostic messages.

Serial A is configured to run at 38400 baud, and uses 8 data bits, 1 stop bit, and no parity.

For PPP examples, connect your modem to Serial Port B on the Integrator/AP.

You can download the target into the Integrator using CodeWarrior by selecting Debug from the CodeWarrior Project menu. The startup commands and sequences for AXD, the debug tool, are defined in the CodeWarrior project, and use command files provided.

The operation of CodeWarrior, MultiIce and AXD are described in the documentation provided with the ARM Developer Suite (ADS).

COM: port of the PC

Serial port A

Integrator

Serial port B

Modem	Phone line

Figure C-1 Running PPP examples

ARM DUI 0144B

<<< < Предыдущая 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 5051 / 5751 52 53 54 55 56 57 > Следующая >>>

Соседние файлы в предмете Электротехника

#
23.08.201343.98 Кб30(ARM).ARM6 in DSP applications.Use of the MUL instruction.pdf
#
23.08.201351.65 Кб29(ARM).Big and little endian byte addressing.pdf
#
23.08.2013144.45 Кб43(ARM).Fixed point arithmetic on the ARM.pdf
#
23.08.201374.92 Кб34(ARM).Floating-point performance.pdf
#
23.08.20132.79 Mб31(ARM).Porting TCP-IP programmer's guide.Ver 1.4.pdf
#
23.08.20132.64 Mб43(ARM).Porting TCP-IP programmer's guide.Ver 1.6.pdf
#
23.08.20131.19 Mб27(ARM).Porting the ARM webserver programmer's guide.Ver 1.6.pdf
#
23.08.2013380.31 Кб29(ARM).Reference peripherals specification.pdf
#
23.08.201386.57 Кб39(ARM).Using the ARM assembler.pdf
#
23.08.2013133.49 Кб66(ARM).Writing efficient C for ARM.pdf
#
23.08.20134.7 Mб89(Ebook) Kluwer Inter - Rf Cmos Power Amplifier (Hella & Ismall).pdf