Ä		INSTRUMENT PANEL AND GAUGES 8E - 13

(3) For installation reverse above procedure. Use care when aligning module to printed circuit board.

GAUGE ALERT MODULE REPLACEMENT

(1)Remove cluster assembly. Refer to Cluster Assembly Replacement.

(2)Pull gauge alert module from printed circuit board (Fig. 33).

(3)For installation reverse above procedures. Use care when aligning module to printed circuit board.

Fig. 33 Gauge Alert Module

CLUSTER LAMP REPLACEMENT

(1)Remove cluster, radio and rear window defogger bezels.

(2)Remove cluster. Refer to Cluster Assembly Replacement.

(3)Remove lamp sockets as necessary by turning them counterclockwise (Fig. 34 and 35).

PRINTED CIRCUIT BOARD REPLACEMENT

(1)Remove cluster assembly.

(2)Remove tachometer drive module, low fuel relay and gauge alert module (Fig. 32).

(3)Remove all cluster lamps.

(4)Remove mounting screws securing printed circuit board to cluster housing (Fig. 34).

(5)For installation reverse above procedures.

ELECTRONIC CLUSTER

SELF DIAGNOSTIC SYSTEM

The electronic clusters (Fig. 36) have an internal diagnostics routing to isolate problems within the cluster or sending units (Fig. 37 and 38).

Successful completion of the SELF DIAGNOSTIC TEST indicates that the problem is in the connectors or sensors outside of the module.

Fig. 34 Mechanical Cluster Lamp Location

8E - 14 INSTRUMENT PANEL AND GAUGES		Ä

Fig. 35 Electronic Cluster Lamp Location