8L - 14 LAMPS

PARK AND TURN SIGNAL LAMP OR BULB

REMOVAL (FIG. 1)

(1)Remove headlamp housing.

(2)Remove the bulb and socket assembly from the lamp. Pull bulb from socket if bulb replacement is required.

(3)Remove screws holding park and turn signal lamp to headlamp housing.

INSTALLATION

Reverse the preceding operation.

FOG LAMP OR BULB

REMOVAL (FIG. 2 AND 3)

(1)Remove screws holding fog lamp to front fascia.

(2)Disengage tabs holding cover to back of fog

lamp.

(3)Separate cover from lamp.

(4)Disengage bulb retainer clip from tabs on back of lamp. Separate clip from lamp.

(5)Pull bulb from lamp.

CAUTION: Do not touch the bulb glass with fingers or other oily surface, as reduced bulb life will result.

INSTALLATION

Reverse the preceding operation. Refer to Fog Lamp Alignment procedures in this group.

Fig. 2 Fog Lamp

Ä

Fig. 3 Fog Lamp Bulb

TAIL, STOP, TURN SIGNAL, SIDE MARKER, BACK-UP LAMP

The lamp must be separated from the rear closure panel to replace the bulbs.

REMOVAL (FIG. 4)

(1)Remove rear lift gate scuff plate.

(2)Remove screws holding tail lamp to rear closure panel.

(3)Separate the lamp from rear closure panel.

(4)Rotate sockets counterclockwise and separate sockets from tail lamp.

(5)Pull bulb from socket if bulb replacement is required.

INSTALLATION

Reverse the preceding operation.

Fig. 4 Tail Lamps

CENTER HIGH MOUNTED STOP LAMP BULB

REMOVAL

(1)Open the lift gate.

(2)Remove the lower scuff plate, reach behind the closure panel, and rotate the bulb and socket counterclockwise and separate socket from the lamp.

(3)Remove bulb from socket.

INSTALLATION

Reverse the preceding operation.