8L - 26 LAMPS					Ä
		EXTERIOR LAMP SYSTEMS
		INDEX
		page		page
Daytime Running LampÐCanada Only		. . . . . . . . . 26	Lamp Outage ModuleÐAll Except AA-Body	. . . . . 26
Headlamp Time Delay System . . . .		. . . . . . . . . . . 27	Lamp Outage Module . . . . . . . . . . . . . . . . .	. . . . . 26
Lamp Outage ModuleÐAA-Body . .		. . . . . . . . . . . 26

LAMP OUTAGE SYSTEM

Diagnostics and component relationships for AC, AG, AJ or AY-Bodies can be found in the Body Diagnostic Procedures Manual, Electronic Vehicle Information Center (EVIC) section.

For circuit and compoenent locations on AA-body, refer to the Wiring Diagrams Manual.

LAMP OUTAGE MODULEÐALL EXCEPT AA-BODY

REMOVAL

(1)Remove battery negative cable.

(2)Remove the glove box assembly. Refer to Group 8E, Instrument Panel.

(3)Disconnect the wire connector from the lamp outage module.

(4)Remove lamp outage module attaching screw and remove the module from the vehicle (Figs. 1, 2 or 3).

INSTALLATION

Reverse the preceding operation.

LAMP OUTAGE MODULEÐAA-BODY

REMOVAL (FIG. 1)

(1)Remove battery negative cable.

(2)Disconnect the wire connectors from the lamp outage module.

(3)Remove screws or clip holding lamp outage module to instrument panel above glove compartment (Fig. 1, 2, or 3).

(4)Separate lamp outage module from vehicle.

INSTALLATION

Reverse the preceding operation.

DAYTIME RUNNING LAMPÐCANADA ONLY

DIAGNOSIS

For circuit and component locations refer to the Wiring Diagrams manual.

REMOVAL (FIG. 4)

(1) Remove the left front inner fender shield, if equipped, and disconnect the wire connector from the day time running lamp module.

Fig. 1 Lamp Outage ModuleÐAA-Body

Fig. 2 Lamp Outage ModuleÐAG and AJ-Body

(2) Remove daytime running lamp module attaching screws and separate the module from the inner fender support.

INSTALLATION

Reverse the preceding operation.