8L - 10 LAMPS		Ä

Fig. 2 Headlamp Close Relay

Fig. 3 Sealed Beam Replacement±Typical

AERO HEADLAMPSÐAC/D-BODY

Lens fogging is a normal condition and does not require service, as moisture will vent from tubes behind the lens.

AERO HEADLAMP BULB

REMOVAL (FIG. 4)

(1) Locate and remove the wire connector behind the headlamp assembly in the engine compartment.

CAUTION: Do not touch the bulb with fingers or any possibly oily surface, reduced bulb life will result.

(2) Rotate the bulb retaining ring counterclockwise one quarter turn and remove the ring, bulb and bulb holder from the lens assembly. The bulb holder has alignment notches.

INSTALLATION

Reverse the preceding operation.

Fig. 4 Aero Headlamp±AC/D-Body

AERO HEADLAMP HOUSING

REMOVAL (FIG. 4 AND 5)

To remove the aero headlamp housing, perform steps (1) and (2) of bulb removal operation and proceed with the following procedures.

(1)The battery may have to be removed to replace the left front headlamp bulb or lens.

(2)From inside the engine compartment, unsnap the headlamp adjuster cables from the headlamp adjuster screws.

(3)Remove the four headlamp lens attaching nuts from behind the grille opening panel, and remove the lamp housing from the vehicle.

INSTALLATION

Reverse the preceding operation.

Fig. 5 Headlamp Adjuster Cables±AC/D-Body