Ä

CONTROL MODULE

REMOVAL

(1)Disconnect negative battery cable.

(2)Remove right side trunk trim panel.

(3)Remove electrical connectors from control module and relay (Fig. 7).

(4)Remove control module mounting screws and remove assembly.

Fig. 7 Control Module and Relay Wiring

INSTALLATION

(1)Install relay on the control module mounting bracket (if required).

(2)Place control module in mounting position.

(3)Install mounting screws and tighten to 2-3 NIm (19-29 in. lbs.).

(4)Install control module and relay wiring connectors (Fig. 7).

(5)Install right side trunk trim panel.

(6)Connect negative battery cable.

SUSPENSION/DRIVESHAFTS 2 - 73

COMPRESSOR RELAY

REMOVAL

(1)Remove right side trunk trim panel.

(2)Remove electrical connector from relay.

(3)Remove relay from control module mounting bracket by prying out on locating clip (Fig. 8).

INSTALLATION

(1)Push relay onto bracket (relay will Lock into position).

(2)Install electrical connector.

(3)Install trim panel.

RIGHT SHOCK ABSORBER (WITH HEIGHT SENSOR)

REMOVAL

(1)Disconnect negative battery cable.

(2)Raise vehicle, see Hoisting, Group 0.

(3)Remove tire assembly.

(4)Disconnect height sensor connector, located on right rear frame rail.

(5)Remove both air lines connected to shock absorber ports.

(6)Remove shock, see Shock Absorbers, Removal.

INSTALLATION

(1)Install shock assembly, see Shock Absorbers, Installation.

(2)Route height sensor wire through clip on shock bracket, then tie strap to fuel filler tube.

(3)Snap height sensor connector into underbody harness connector.

(4)Insert air lines.

(5)Install wheel/tire assembly.

Fig. 8 Control Module Connector