Visit the Alpha website at www.alpha.ca for the latest manual and product downloads

7.

Figure 26–Firmware upgrade procedure

NOTE: Repeat the steps above choosing Shunt MUX as required.

6.1.3Set ADIO Module Number

This menu item enables the Supervisor to select and map the order number in which CAN-enabled system devices, such as Battery Cell Monitor (BCM), are to appear in the CXC menus; shown in the examples below:

Select module for mapping; e.g. module 2

The module number is important when any of the signals from an ADIO device is used for custom signals or

data logging.

Discard changes and return to previous screen

Tap arrows to increase or decrease value as required

Accept changes and return to previous screen

Figure 27–ADIO Modules and Swap Modules windows

NOTE: When replacing ADIO modules, assign the new identical device with the same ADIO module number of the old device. This is to preserve the functionality of any equations that use signals originating on the old device.

6.1.4Site Information

6.1.4.1System Number

This is where the power system number is displayed/edited.

6.1.4.2System Serial

This is where the power system serial number is displayed/edited.

Figure 28–Site Information and Contact Information windows

0350046-J0 Rev C

Page 35 of 127