Visit the Alpha website at www.alpha.ca for the latest manual and product downloads

6.1.9System Inventory (Web Interface Only)

This page enables the user to view a single list of all CAN connected devices, user inventory items, and battery information items. See Figure 31 below:

Select pull-down menu for device details:

Figure 31–System Inventory window (web interface only)

6.2Converters

This menu category consists of converter alarms and controls. Parameters can be set/accessed such as output voltage, OVP, high/low voltage alarms, and start delay.

The converter defaults will be based on the system voltage if it is either 24 or 48Vdc.

NOTE: At present, the converter software does not support:

•Two types of converters simultaneously

•12, 125, and 220Vdc systems.

Other features include:
Active voltage control	Inventory update
Converter locate	Loadsharing
Firmware upgrade	Major and minor alarms

6.2.1Converter Report

This feature will enable the user to view, in a list report (see 4.4.2, Figure 9), all of the acquired converters in the system. The first column lists the serial numbers of the converters. The report then displays the output current of each converter under the Amps column (or toggle for % of maximum output) and the number of active alarms under the Alarms column (if that converter is issuing an alarm). The rightmost column displays the number of settings out of tolerance (OOT per web interface).

Select a converter and tap “View Details” to produce another list showing details of the entire converter alarms and settings that are out of tolerance.

6.2.2Configure Settings

This feature will enable the user to configure settings (via menu items) for all of the acquired converters in the system; such as:

Output Voltage	Start Delay
OVP	Enable CL Alarm
Input Voltage Shutdown	Input Voltage Restart
0350046-J0 Rev C	Page 37 of 127