Optical drive connector cable
Description |
Spare part number |
|
|
Optical drive connector cable |
686257-001 |
|
|
Before removing the optical drive connector cable, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 35), and then remove the following components:
a.Memory module/wireless module compartment cover (see Memory module on page 36)
b.Keyboard (see Keyboard on page 39)
c.Hard drive (see Hard drive on page 45)
d.Top cover (see Top cover on page 49)
Remove the optical drive connector cable:
1.Disconnect the optical drive connector cable (1) from the system board.
2.Release the optical drive connector cable from the clips (2) and routing channel built into the base enclosure.
3.Remove the two Phillips PM2.0×4.5 screws (3) that secure the optical drive connector to the base enclosure.
56 |
Chapter 4 Removal and replacement procedures |
4.Remove the optical drive connector cable (4).
Reverse this procedure to install the optical drive connector cable.
Component replacement procedures |
57 |
Speakers
Description |
Spare part number |
|
|
Speakers (include speaker cables) |
686279-001 |
|
|
Before removing the speakers, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 35), and then remove the following components:
a.Memory module/wireless module compartment cover (see Memory module on page 36)
b.Keyboard (see Keyboard on page 39)
c.Hard drive (see Hard drive on page 45)
d.Top cover (see Top cover on page 49)
Remove the speakers:
1.Disconnect the speaker cable (1) from the system board.
2.Release the speaker cable from the clips (2) and routing channel built into the base enclosure.
3.Remove the two Phillips PM2.5×4.0 screws (3) that secure the speakers to the base enclosure.
58 |
Chapter 4 Removal and replacement procedures |
4.Remove the speakers (4).
Reverse this procedure to install the speakers.
Component replacement procedures |
59 |