Ä

(2)Disengage snap-on linkage at rear of air deflector in sun roof opening.

(3)Remove screws holding air deflector to front of sun roof opening.

INSTALLATION

Reverse the preceding operation.

SUN ROOF DRAIN TUBES

REMOVAL (FIG. 42)

(1)Remove head lining as necessary.

(2)Remove A-pillar or B-pillar trim covers as necessary.

(3)Remove cowl panel and sill plate trim as neces-

sary.

(4)Disconnect effected drain tube from nipple at sun roof opening.

(5)Pull drain tube upward to remove from pillar involved.

INSTALLATION

Reverse the preceding operation. Route the tube to avoid kinks or puncture from sharp edges.

AP-BODY 23 - 109

LIFT GATE REMOTE RELEASE CABLE

REMOVAL

(1)Remove interior trim as necessary to gain access to release cables.

(2)Remove left front door scuff plate.

(3)Remove screw holding trim cover to release cable handle and separate cover from handle.

(4)Remove screw holding release handle to door

sill.

(5)Pry open retainer tab holding cable core end in handle pivot. Pry cable case end from handle.

(6)Remove trunk lining as necessary to gain access to the release cable.

(7)Disconnect cable end from latch.

(8)Separate cable from vehicle.

INSTALLATION

Reverse the preceding operation.

REAR WINDOW GLASS

REMOVAL (FIG. 43)

(1)Raise lift gate to up position.

(2)Remove screws holding outward edges to rear window moulding to lift gate frame.

(3)Position protective card board covers along the top of the quarter panels to protect painted surfaces.

Fig. 42 Sun Roof