23 - 58 AG-BODY

MANUAL WINDOW REGULATOR

REMOVAL (FIG. 16)

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Raise glass to 25 mm (1 in.) below full up position and support glass to keep the glass from falling.

(4)Remove bolts holding regulator to inner door panel.

(5)Remove nuts holding lift plate to glass.

(6)Remove regulator assembly through access hole in door.

INSTALLATION

Reverse the preceding operation.

Fig. 16 Manual Window Regulator

MANUAL WINDOW LIFT PLATE AND GUIDE

REMOVAL (FIG. 16)

(1)Remove door trim panel, silencer and water shield.

(2)Raise glass enough to align lift plate to large access hole in inner door panel.

(3)Remove nuts holding glass to lift plate.

(4)Separate glass from lift plate and allow glass to rest on bottom of door.

(5)Remove bolt holding guide bar to upper door frame.

(6)Remove bolts holding guide bar top inner door panel.

(7)Slide regulator lift arm roller from lift plate channel.

(8)Remove lift plate and guide bar through large access hole in inner door panel.

INSTALLATION

Reverse the preceding operation.

Ä

DOOR GLASS

REMOVAL (FIG. 17)

(1)Remove door trim panel.

(2)Remove silencer and water shield.

(3)Raise door glass 100 mm (4 in.) from down position.

(4)Disconnect battery negative cable if equipped with power windows.

(5)Loosen bolts holding glass stabilizers and guide hook receiver to top of inner door frame.

(6)Remove nuts holding door glass to lift plate.

(7)Separate glass from lift plate and lift glass upward from opening at top of door.

INSTALLATION

Reverse the preceding operation.

Fig. 17 Door Glass

GLASS RUN WEATHERSTRIP

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Remove side view mirror cover.

(4)Pull glass run weatherstrip from door frame channel.

INSTALLATION

Reverse the preceding operation.

OUTSIDE DOOR LATCH RELEASE HANDLE

REMOVAL (FIG. 18)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Raise door glass to full up position.

(3)Disconnect security alarm switch and illuminated entry switch from back of outside front door latch release handle, if equipped. For additional information refer to Group 8Q, Vehicle Theft Security System

(4)Disconnect lock rod and latch release rod from door latch assembly.