23 - 24 AA-BODY		Ä

Fig. 35 Rear Door Window RegulatorÐManual

(2)Position door glass 150 mm (6 in.) up into glass opening. Firmly pull upward at front edge of glass to disengage lower glass run guide from division channel.

(3)Remove bolts holding window regulator to inner door panel.

(4)Slide roller from window lift channel.

(5)By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.

(6)Remove regulator assembly from door.

POWER WINDOW REGULATOR INSTALLATION

Reverse the preceding operation.

Fig. 36 Rear Door Window RegulatorÐPower

DOOR OPENING WEATHERSTRIPS

FRONT OR REAR DOOR OPENING WEATHERSTRIP REMOVAL (FIG. 37)

(1)Remove interior trim as necessary to gain access to door opening weatherstrip.

(2)Pull weatherstrip from pinch flange around door opening.

FRONT OR REAR DOOR OPENING WEATHERSTRIP INSTALLATION

(1)Locate the middle to the weatherstrip at the center of the upper pinch flange. Push weatherstrip onto pinch flange at the top corner near the B-pillar.

(2)When the weatherstrip has been installed down the door opening to the sill pinch flange, mate the ends of the weatherstrip together and finish installing.

Fig. 37 Door Opening Weatherstrips

BODY SIDE MOULDING AND APPLIQUE

STICK-ON BODY SIDE MOULDING REMOVAL AND INSTALLATION (FIG. 38)

(1)Warm the effected stick-on moulding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.

(2)Pull stick-on moulding from painted surface.

(3)Remove adhesive tape residue from painted surface of vehicle.

(4)If moulding is to be reused, Remove tape residue from moulding. Clean back of moulding with Mopar, Super Kleen solvent or equivalent. Wipe moulding dry with lint free cloth. Apply new body side moulding (two sided adhesive) tape to back of moulding.

(5)Clean body surface with Mopar, Super Kleen solvent or equivalent. Wipe surface dry with lint free cloth.

(6)Apply a length of masking tape on the body, parallel to the top edge of the moulding to use as a guide, if necessary.

(7)Remove protective cover from tape on back of moulding. Apply moulding to body below the masking tape guide.

(8)Remove masking tape guide and heat body and moulding, see step one. Firmly press moulding to body surface to assure adhesion.