Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 74 AJ-BODY

ENGINE DRIVE BELT SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

Fig. 7 Engine Drive Belt Splash ShieldÐTypical

DOOR TRIM PANEL

REMOVAL (FIG. 8)

(1)Lower door glass and disconnect battery negative cable.

(2)Remove courtesy lamp and remove socket.

(3)Remove screw holding trim panel to door from courtesy lamp opening.

(4)Disengage clips holding speaker grille to trim panel and separate grille from door.

(5)Remove screw holding trim panel to door from speaker grille opening.

(6)Remove screw holding inside latch handle bezel to trim panel and separate bezel from door. Disconnect power door lock switch wire connector, if equipped.

(7)Remove window crank, if equipped.

(8)Remove screw holding trim panel to door from arm rest pull cup opening.

(9)Remove hidden screws holding trim panel to door from carpet area at bottom of trim.

(10)Lift trim panel upward and separate panel from door.

(11)Disconnect radio speaker, power window and power mirror wire connectors, if equipped.

INSTALLATION

Reverse the preceding operation.

FRONT DOOR SILENCER AND WATER SHIELD

REMOVAL (FIG. 9)

(1)Remove front door trim panel.

(2)Remove push-in fasteners holding silencer pad to door inner panel and separate silencer from door.

(3)Pull water shield from adhesive around perimeter of door inner panel.

Ä

Fig. 8 Door Trim Panel

INSTALLATION

Reverse the preceding operation.

Fig. 9 Front Door Silencer and Water

ShieldÐTypical

FRONT DOOR AND HINGE

The front door hinge is welded to the door and bolted to the hinge pillar. The door half of the hinge pivots on a removable hinge pin. The hinge pin is driven in from the bottom on the top hinge and from the top on the bottom hinge. All adjustments to the hinge are performed on the hinge pillar half of the hinge. If the welded half of the hinge must be bent to align door, consult an authorized body repair facility.

FRONT DOOR REMOVAL (FIG. 10)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Disconnect all wire connectors and wire harness hold downs inside door and push wire harness through access hole in front of door into hinge pillar opening.

(3)Open door and support door on a suitable lifting device.

Соседние файлы в папке FWD