Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 76 AJ-BODY

GLASS RUN WEATHERSTRIPÐAJ-21 BODY

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Remove side view mirror cover.

(4)Pull glass run weatherstrip from door frame channel.

INSTALLATION

Reverse the preceding operation.

OUTSIDE DOOR LATCH RELEASE HANDLE

REMOVAL (FIG. 11)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Raise door glass to full up position.

(3)Disconnect security alarm switch and illuminated entry switch from back of outside front door latch release handle, if equipped. For additional information refer to Group 8Q, Vehicle Theft Security System

(4)Disconnect lock rod and latch release rod from door latch assembly.

(5)Remove nuts holding outside door latch handle to retainer bracket and separate bracket from door.

(6)Swing lock rod upward, parallel to back of latch handle, and separate latch handle from door panel.

INSTALLATION

Reverse the preceding operation.

Fig. 11 Outside Door Latch Release HandleÐTypical

INSIDE LATCH RELEASE HANDLE

REMOVAL

(1)Remove door trim panel.

(2)Remove screw holding handle to inner door panel.

(3)Disconnect linkage rod from back of handle.

(4)Separate handle from door.

Ä

INSTALLATION

Reverse the preceding operation.

POWER DOOR LOCK ACTUATOR

REMOVAL

(1)Remove door trim panel. Remove silencer and water shield as necessary.

(2)Raise door glass to the up position.

(3)Disconnect battery negative cable.

(4)Disconnect lock actuator linkage rod from door

latch.

(5)Remove bolts holding actuator to inner door panel.

(6)Separate power door lock actuator from door.

INSTALLATION

Reverse the preceding operation.

COWL PANEL TRIM AND SCUFF PLATES

COWL PANEL AND DOOR OPENING SCUFF PLATE REMOVAL (FIG. 12)

(1)Open front door.

(2)Remove screw holding trim panel to cowl forward of the front door opening.

(3)Remove screws holding scuff plate to door sill.

(4)Separate cowl panel trim and scuff plate from vehicle.

COWL PANEL AND DOOR OPENING SCUFF PLATE INSTALLATION

Reverse the preceding operation.

A-PILLAR AND ROOF RAIL MOULDINGS

A-PILLAR MOULDING REMOVAL (FIG. 12)

(1)Open front door.

(2)Disengage clips holding A-pillar moulding to roof rail above door opening.

(3)Slide A-pillar moulding upward and pull rearward to separate moulding from A-pillar.

A-PILLAR MOULDING INSTALLATION

Reverse the preceding operation.

QUARTER TRIM PANEL

QUARTER TRIM PANEL REMOVAL (FIG. 12)

(1)Remove A-pillar moulding and scuff plate as necessary.

(2)Remove front shoulder harness turning loop cover. Remove bolt holding turning loop to quarter panel.

(3)Remove bolt holding rear shoulder harness anchor to floor.

(4)Remove rear seat cushion and back.

(5)Remove screw holding quarter trim to roof rail.

Соседние файлы в папке FWD