Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 62 AG-BODY

 

Ä

 

(9)Remove screws holding upper quarter trim to quarter panel.

(10)Raise and support lift gate in the up position. Disconnect bottom of lift cylinder.

(11)Swing rear of trim panel away from quarter panel and pull trim forward to clear door opening flange.

(12)Separate upper quarter trim panel from ve-

hicle.

INSTALLATION

Reverse the preceding operation.

LOWER TAIL PANEL TRIM COVER

REMOVAL (FIG. 24)

(1)Raise lift gate to the up position.

(2)Remove hidden screws holding tail panel trim cover to tail panel from carpeted area.

(3)Remove push-in fasteners holding top tail panel trim to opening sill.

(4)Lift up floor cover and position cover out of the

way.

(5)Separate cover from vehicle.

INSTALLATION

Reverse the preceding operation.

LIFT GATE TRIM

REMOVAL (FIG. 25)

(1)Raise the lift to the up position.

(2)Disengage clips holding side moldings to lift gate. Separate moldings from lift gate.

(3)Remove expanding push-in fasteners holding upper trim panel to lift gate.

(4)Remove screw plugs and screws holding upper trim panel to lift gate. Separate upper trim panel from lift gate.

(5)Remove screw plug and screw holding lower trim panel to rear window wiper motor, if equipped.

(6)Remove screws holding lower trim panel to lift gate. Separate lower trim panel from lift gate.

INSTALLATION

Reverse the preceding operation.

FRONT SEAT BELTS

OUTBOARD SHOULDER HARNESS/LAP BELT REMOVAL (FIG. 26)

(1)Adjust front seat to the forward position.

(2)Remove bolt holding outboard lap belt anchor to floor below door sill.

(3)Remove lower and upper quarter trim panels as necessary to gain access to shoulder harness turning loop and retractor.

(4)Remove bolt holding shoulder turning loop to B-pillar.

Fig. 25 Lift Gate Trim

(5)Remove bolt holding belt retractor to quarter panel.

(6)Separate belt from vehicle.

OUTBOARD SHOULDER HARNESS/LAP BELT INSTALLATION

Reverse the preceding operation.

INBOARD BUCKLE REMOVAL (FIG. 26)

(1)Remove bolt holding inboard buckle to floor.

(2)Disconnect seat belt sensor wire connector, if equipped.

(3)Separate buckle assembly from vehicle.

INBOARD BUCKLE INSTALLATION

Reverse the preceding operation.

Fig. 26 Front Seat BeltsÐTypical

Соседние файлы в папке FWD