Ä

Fig. 32 Rear Door Belt Moulding and Weatherstrip

(3) Separate glass run weatherstrip from door.

INSTALLATION

(1)Insert glass run weatherstrip into top of glass opening upper channel. Align molded corner of weatherstrip to upper front corner of glass opening.

(2)Push weatherstrip into upper rear corner of door frame above division channel.

(3)Install door belt moulding and weatherstrip assembly.

Fig. 33 Rear Door Glass Run Weatherstrip

REAR DOOR GLASS STATIONARY GLASS MODULE

STATIONARY GLASS MODULE REMOVAL (FIG. 34)

(1)Remove belt moulding and weatherstrip assem-

bly.

(2)Remove upper window opening moulding.

(3)Remove bolts and screws holding division channel and glass module to door assembly and separate module from door frame.

(4)Remove module through opening at top of door.

AA-BODY 23 - 23

STATIONARY GLASS MODULE INSTALLATION

Reverse the preceding operation. Use two sided adhesive tape to secure module weatherstrip to inside of door frame.

Fig. 34 Rear Door Stationary Glass Module

REAR DOOR WINDOW REGULATOR/MANUAL

MANUAL WINDOW REGULATOR REMOVAL (FIG. 35)

(1)Remove trim panel, silencer pad, and water shield.

(2)Position door glass 150 mm (6 in.) up into glass opening. Pull upward firmly at front edge of glass to disengage lower glass run guide from division channel.

(3)Remove bolts holding window regulator to inner door panel.

(4)Slide roller from window lift channel.

(5)By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.

(6)Remove regulator assembly from door.

MANUAL WINDOW REGULATOR INSTALLATION

Reverse the preceding operation.

REAR DOOR WINDOW REGULATOR/POWER

POWER WINDOW REGULATOR REMOVAL (FIG. 36)

(1) Remove trim panel, silencer pad, and water shield.