Ä

OVERHEAD CONSOLE

REMOVAL (FIG. 33)

(1)Remove screws holding overhead console to reinforcement bracket.

(2)Slide overhead console rearward to separate reinforcement bracket retainer tab from console.

(3)Lower console from roof and disconnect wire connectors.

INSTALLATION

Reverse The preceding operation.

Fig. 33 Overhead ConsoleÐTypical

HEAD LINING

REMOVAL

(1)Disconnect battery negative cable.

(2)Pull dome lamp downward to disengage from retaining ring in head lining. Separate lens from lamp body and remove bulb. Separate bulb holder from lamp body. Remove attaching screw holding retaining ring to roof bow, if equipped.

(3)Remove screws holding coat hooks to roof above quarter panels.

(4)Remove roof rail and A-pillar mouldings.

(5)Remove screws holding sun visors to roof header and disconnect wire connector, if equipped. Remove inboard sun visor hangers.

(6)Remove overhead console, if equipped.

(7)Pull front reading lamp downward to disengage from retaining ring in head lining and disconnect wire connector. Remove screws holding retaining ring to roof header, if equipped.

(8)Remove pinch welt holding headlining to sun roof opening, if equipped.

(9)Remove screws holding lift gate opening header moulding to rear roof header. Separate moulding from header.

(10)Remove one quarter trim panel as necessary to clear head lining removal path.

(11)Remove head lining from vehicle.

AG-BODY 23 - 65

INSTALLATION

Reverse the preceding operation.

SUNROOF LIFT CONTROL

REMOVAL (FIG. 34)

(1)Remove sunroof glass panel. Refer to Owners manual for proper procedures.

(2)Remove pinch welt holding head lining to edge of sunroof opening.

(3)Remove trim ring from tilt control handle.

(4)Remove screws holding tilt control handle to tilt control. Separate handle from control.

(5)Remove nuts holding lift control to roof panel. Separate lift control from roof.

INSTALLATION

Reverse the preceding operation.

REAR WINDOW GLASS

The rear window moulding often cannot be salvaged after removal operation is completed. Verify moulding availability from the parts supplier before removing moulding.

REMOVAL (FIG. 35)

(1)Remove rear window moulding.

(2)Remove lift gate trim as necessary to gain access to rear window defogger wire connector and ground screw, if equipped.

WARNING: WEAR EYE AND HAND PROTECTION WHEN HANDLING SAFETY GLASS. PERSONAL INJURY CAN RESULT.

CAUTION: Do not damage body or trim finish when cutting out glass or applying fence primer.

(3)Cut the urethane around the perimeter of the back window glass. Refer to Windshield section of this group for proper procedures.

(4)Separate the rear window from the vehicle.

INSTALLATION

(1)Prepare the work area, window fence, and glass the same way as described in the Windshield section of this group.

(2)Place the fence spacers at the locations shown (Fig. 35).

(3)Apply a 10 mm (0.4 in.) bead of urethane around the perimeter of the glass.

(4)Install the glass in the same manner described in the Windshield section of this group.

(5)Install the rear window moulding. Apply 50 mm (2 in.) masking tape over moulding to assure alignment.

(6)Connect rear window defogger wiring and install lift gate trim.