Ä		AA-BODY 23 - 35

REMOVAL (FIG. 56)

AA-C MODELS

(1)Remove trunk lid tail light assembly. Refer to Group 8L, Lamps for proper procedures.

(2)Remove trunk latch.

(3)Remove bolts holding lock cylinder and chill to trunk lid and separate the lock from the vehicle.

INSTALLATION

Reverse the preceding operation.

Fig. 56 Trunk Lid Lock

TRUNK OPENING WEATHERSTRIP

REMOVAL(FIG. 57)

(1)Raise trunk lid to the full up position.

(2)Pull the weatherstrip from the pinch flange around the trunk opening.

INSTALLATION

A new trunk lid opening weatherstrip should be heated to approximately 38° C (100° F) before installing. The weatherstrip butt splice should be located at the center rear of trunk opening. Reverse the removal operation. After weatherstrip has been installed, close trunk lid and allow weatherstrip to cool. The weatherstrip will form to the trunk lid contour as it cools.

TRUNK LINING

REMOVAL (FIG. 58)

(1)Remove spare tire and emergency jack from the spare tire well.

(2)Remove screws holding trunk lining to tail closure panel.

(3)Remove screws holding trunk lining to inner quarter panels.

(4)Remove push-in fasteners holding lining to rear seat bulkhead. Remove seat back silencer, if equipped.

Fig. 57 Trunk Opening Weatherstrip

(5)Remove push-in fasteners holding rear seat back carpet covers to floor pan, if equipped with 60/40 rear seat back.

(6)Fold trunk lining inward, away from quarter panels and remove lining from vehicle.

INSTALLATION

Route the fuel fill door emergency release cable around rear edge of trunk lining side panel and reverse the removal operation.

Fig. 58 Trunk Lining

TRUNK LID LUGGAGE RACK

REMOVAL (FIG. 59)

(1)Remove screws holding cross bar to outboard skid strips.

(2)Pry rubber inserts from skid strips.