Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

 

BODY 23 - 7

 

(2)position wind deflector so 19 mm (0.75 in.) above top surface of roof panel and 1 mm (0.040 in.) rearward of roof panel forward edge.

(3)Secure wind deflector to sunroof unit.

GLASS PANEL

GLASS PANEL REMOVAL

(1)Remove wind deflector mechanism covers (Fig.

1).

(2)Position glass to vent position.

(3)Position sunshade full rearward.

(4)Loosen nuts holding glass panel to side adjustment brackets.

(5)Slide glass panel rearward 12 mm (0.5 in.) and separate glass from sunroof unit.

GLASS PANEL INSTALLATION

(1)Position glass panel in opening with logo rearward and slide panel forward 12 mm (0.5 in.).

(2)Verify that attaching nuts are below top surface of glass adjustment brackets.

(3)Close sunroof to center glass panel in roof open-

ing.

(4)Tighten center screws to hold adjustment.

(5)Open glass to vent position and tighten nuts to 8 NIm (70.8 in-lbs.).

(6)Close glass and check alignment.

(7)Install the mechanism covers.

(8)Adjust wind deflector, if necessary.

ADJUSTMENT BRACKET

ADJUSTMENT BRACKET REMOVAL (FIG. 3)

(1)Remove wind deflector, mechanism covers and glass panel.

(2)Move glass carriage to vent position and remove rearward adjustment bolt from adjustment bracket.

(3)Lift rear of adjustment bracket to highest vertical position and disengage front of bracket from unit.

ADJUSTMENT BRACKET INSTALLATION

Reverse the preceding operation. Adjust glass, and wind deflector as necessary.

DRAIN CHANNEL

DRAIN CHANNEL REMOVAL

(1)Remove wind deflector mechanism covers and glass panel.

(2)Locate glass carriage to vent position and drain channel in full forward position.

(3)Remove screws holding drain channel to support frame.

DRAIN CHANNEL INSTALLATION

Reverse the preceding operation.

Fig. 3 Glass Height Vertical Adjustment

DRIVE CABLE LOCATORS

DRIVE CABLE LOCATORS REMOVAL (FIG. 4)

(1)Position glass 19 mm (0.75 in.) until rearward until cable locator is visible.

(2)Remove screws holding drive cable locator to

unit.

(3)Remove travel limiting micro switch grommet and disconnect wire connector.

(4)Insert a small screwdriver under rear edge of locator and pry locator from track.

DRIVE CABLE LOCATORS INSTALLATION

Reverse the preceding operation. The small outboard lip underneath cable locator slips under bottom slot on guide track. After locator is seated install screws.

Fig. 4 Removing Cable Drive Locator

MOTOR AND DRIVE GEARS

MOTOR AND DRIVE GEAR REMOVAL (FIG. 5)

(1)Open sunroof to vent position.

(2)Remove head lining.

Соседние файлы в папке FWD