Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

 

AY-BODY 23 - 131

 

Fig. 10 Engine Drive Belt Splash ShieldÐTypical

(6)Disengage frog-leg fasteners holding trim panel to inner door panel.

(7)Lift trim panel upward and separate trim from

door.

(8)Disconnect courtesy lamp, power door lock switch and power window switch wire connectors.

TRIM PANEL INSTALLATION

Reverse the preceding operation.

Fig. 11 Front Door Trim Panel

SIDE VIEW MIRROR TRIM COVER

REMOVAL

(1)Remove Front door trim panel.

(2)Disconnect power mirror wire connector.

(3)Remove screws holding mirror trim cover to door frame.

INSTALLATION

Reverse the preceding operation.

DOOR FRAME TRIM MOULDING

REMOVAL (FIG. 11)

(1)Remove front door trim panel.

(2)Disengage trim clips holding moulding to window opening frame and separate moulding from door.

INSTALLATION

Reverse the preceding operation.

FRONT DOOR SILENCER AND WATER SHIELD

REMOVAL

(1)Remove front door trim panel.

(2)Pull water shield from adhesive around perimeter of door inner panel.

INSTALLATION

Reverse the preceding operation.

FRONT DOOR AND HINGE

The front door hinge is welded to the door and bolted to the hinge pillar. The door half of the hinge pivots on a removable hinge pin. The hinge pin is driven in from the bottom on the top hinge and from the top on the bottom hinge. All adjustments to the hinge are performed on the hinge pillar half of the hinge. If the welded half of the hinge must be bent to align door, consult an authorized body repair facility.

FRONT DOOR REMOVAL (FIG. 12)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Disconnect all wire connectors and wire harness hold downs inside door and push wire harness through access hole in front of door into hinge pillar opening.

(3)Open door and support door on a suitable lifting device.

(4)Drive bottom hinge pin upward and remove pin from hinge.

(5)Drive top hinge pin downward and remove pin from hinge.

FRONT DOOR INSTALLATION

Reverse the preceding operation. The door should not require re-alignment. If door does need alignment, refer to Front Door Hinge Installation paragraph in this section.

FRONT DOOR HINGE REMOVAL (FIG. 12)

(1)Remove front fender wheelhouse splash shield. Refer to Front Wheelhouse Splash Shield Removal paragraph in this section.

(2)Support door on a suitable lifting device.

(3)Drive out hinge pin on the effected hinge.

Соседние файлы в папке FWD