23 - 8 BODY		Ä

(3)Remove bolts holding sunroof motor to motor bracket.

(4)Disconnect wire connector.

(5)Separate motor and drive gear from drive cables.

MOTOR AND DRIVE GEAR INSTALLATION

(1)Verify that sunroof is in vent position. Push mechanism forward on both sides to align drive cables.

(2)Engage drive gears onto drive cables.

(3)Install motor and drive gear screws and tighten to 5 NIm (44 in-lbs.).

(4)Install head lining.

Fig. 5 Sunroof Motor and Drive Gear

DRIVE CABLES

DRIVE CABLES REMOVAL (FIG. 6)

(1)Open sunroof to vent position.

(2)Remove head lining, wind deflector, mechanism covers, glass panel, side glass adjustment brackets, motor and drive cable locators.

(3)Lift cable out of cable retainer and pull forward. Separate cable from assembly.

DRIVE CABLES INSTALLATION

Verify sunroof is in vent position. Push mechanism forward on both sides to align drive cables. Reverse the preceding operation.

SUNSHADE

SUNSHADE REMOVAL (FIG. 7)

(1)Remove wind deflector, mechanism covers and glass panel.

(2)Position system to full rearward position.

(3)Slide sunshade panel full forward and release the front tabs from track assembly.

(4)Pull rear retaining clip inboard and lift sun shade out.

Fig. 6 Drive Cables

SUNSHADE INSTALLATION

Reverse the preceding operation.

Fig. 7 Sunshade Assembly

GUIDE ASSEMBLY

GUIDE ASSEMBLY REMOVAL (FIG. 8)

(1)Remove wind deflector, mechanism covers, glass panel, drain channel, sunshade and drive cable locator as necessary.

(2)Move glass carriage to vent position.

(3)Remove front slide from guide assembly.

(4)Remove screws holding front and center guide track to unit.

(5)Pull cable out of groove for cable end.

(6)Pull guide outward to release from housing. Separate rear end of guide from clips. Slide guide out of unit.

GUIDE ASSEMBLY INSTALLATION

(1)Install guide cable into rear of guide assembly.

(2)Install guide assembly at an angle so the rear portion slips under finger clips at rear of module housing.