Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

 

AJ/27-BODY 23 - 89

 

(2) Disconnect hydraulic lines from pump and remove seals.

HYDRAULIC PUMP LINE SEALS INSTALLATION

Reverse the preceding operation.

HYDRAULIC CYLINDER LINE SEALS

REMOVAL

(1)Remove hydraulic cylinder to gain access to hydraulic line connections.

(2)Disconnect hydraulic lines from cylinder and remove seals.

INSTALLATION

Reverse the preceding operation.

QUARTER WINDOW

REMOVAL

(1)Disengage snaps holding the sling well from the tacking strip below rear window.

(2)From each side of vehicle, Disengage clips holding sling well to belt reinforcement brace. Drape sling well over rear seat back into passenger compartment.

(3)Remove screw holding quarter trim panel and door weatherstrip to door opening.

(4)Remove the cowl trim and scuff plate covers.

(5)Remove the rear seat cushion.

(6)Disconnect rear speaker wire connectors.

(7)Remove screws holding seat back to floor brackets and rear shoulder belt retractors (Fig. 6). Separate rear seat back from vehicle.

(8)Remove screws holding quarter trim to quarter panel at the boot latches.

(9)Remove screws holding quarter trim to floor pan kick up.

(10)Separate quarter trim from rear reinforcement. Position trim panel out of quarter window removal path (Fig. 7).

(11)Raise quarter window approximately 100 mm (4 in.) from the down position.

(12)Remove bolt holding glass stabilizer bumper to top of quarter panel opening.

(13)Disconnect power window motor wire connec-

tor.

(14)Remove bolts holding quarter window assembly to quarter panel and lift the assembly through the opening at the top of the quarter panel.

INSTALLATION

Reverse the preceding operation. Align the quarter glass to have adequate pressure on the weatherstrips for proper sealing. Insert sling well drain tubes into the holes in the floor pan.

Fig. 6 Rear Seat Back

Fig. 7 Quarter Trim Panel

REAR SEAT BELT RETRACTORS

REMOVAL (FIG. 8)

(1)Remove rear seat as necessary to gain access to rear seat belts.

(2)Remove bolt holding shoulder belt turning loop to seat back reinforcement panel.

(3)Remove bolts holding rear seat belt retractor to floor kick-up

(4)Remove bolts holding retractor to quarter panel reinforcement.

(5)Remove bolts holding lap belt to lower quarter panel reinforcement.

(6)Separate seat belt retractor from vehicle.

INSTALLATION

Reverse the preceding operation.

23 - 90 AJ/27-BODY

 

Ä

 

Fig. 8 Rear Seat Belts

Соседние файлы в папке FWD