23 - 18 AA-BODY

BELT MOULDING AND WEATHERSTRIP INSTALLATION

Reverse the preceding operation.

Fig. 18 Front Door Belt Moulding and Weatherstrip

FRONT DOOR GLASS CHANNEL AND RUN WEATHERSTRIP

GLASS CHANNEL AND RUN WEATHERSTRIP REMOVAL (FIG. 19)

(1)Remove door belt moulding and weatherstrip assembly.

(2)Remove front and rear door glass opening corner seals (Fig. 18)

(3)Pull door glass run weatherstrip from forward lower channel and upper door frame back to rear upper corner of door frame.

(4)Separate weatherstrip from top of rear door frame down to first clip. Using a suitable hook tool, disengage clip barb from door frame channel. Pull weatherstrip outward to disengage clip. Repeat this procedure at each clip down the rear channel.

(5)Separate glass channel and run weatherstrip from door.

GLASS CHANNEL AND RUN WEATHERSTRIP INSTALLATION

(1)Insert glass run weatherstrip into top of glass opening upper channel. Align molded corners of weatherstrip to corners of glass opening.

(2)Push weatherstrip and glass run channel into upper rear glass opening channel. Seat the top retaining clip by placing a fiber trim stick (C-4755) over the clip attaching rivet inside the glass run channel and push or tap firmly inward until clip seats. Verify the alignment of the weatherstrip in the top rear corner. Repeat this procedure on each clip going down the run.

(3)Install glass opening corner seals.

(4)Install door belt moulding and weatherstrip assembly.

Ä

Fig. 19 Front Door Glass Channel and Run Weather-

strip

FRONT DOOR GLASS RUN LOWER CHANNEL

FRONT OR REAR LOWER CHANNEL REMOVAL (FIG. 20)

(1)Remove door glass channel and run weatherstrip as necessary to gain access to lower channels and attaching rivets.

(2)Drift punch rivet center expansion pins from each pop-rivet fastener holding channel to door panel or mirror support frame.

(3)Drill pop-rivet fasteners out of door panel or mirror support frame and separate front or rear channel from door.

FRONT OR REAR LOWER CHANNEL INSTALLATION

(1)Install lower channel into at design location.

(2)Install pop-rivets using a suitable pop-rivet gun.

(3)Install Glass channel and run weatherstrip.

(4)Install belt moulding and weatherstrip assem-

bly.

(5)Install door glass.

(6)Install window opening lower corner seals.

(7)Install door water shield silencer pad and trim panel.

FRONT DOOR WINDOW REGULATOR/MANUAL

MANUAL WINDOW REGULATOR REMOVAL (FIG. 21)

(1) Remove trim panel, silencer pad, and water shield.