23 - 52	AG-BODY					Ä
			AG-VEHICLE BODY COMPONENT SERVICE
				INDEX
				page		page
	A-Pillar and Roof Rail Mouldings . . . . . . . . . . . .			. 61	Lift Gate . . . . . . . . . . . . . . . . . . . . . . . . . .	. . . . . 68
	Body Side Applique . . . . . . . . . . . . . . . . . . . . . .			. 60	Lift Gate and Fuel Fill Door Release Cables	. . . . . 69
	Body Side Mouldings . . . . . . . . . . . . . . . . . . . . .			. 60	Lift Gate Latch and Striker . . . . . . . . . . . . .	. . . . . 68
	Closure Panel Sight Shield . . . . . . . . . . . . . . . . .			. 52	Lift Gate Lock Cylinder . . . . . . . . . . . . . . . . .	. . . . 68
	Cowl Cover	. . . . . . .	. . . . . . . . . . . . . . . . . . . . .	. 54	Lift Gate Prop Cylinder . . . . . . . . . . . . . . . . .	. . . . 67
	Door Glass	. . . . . . .	. . . . . . . . . . . . . . . . . . . . .	. 58	Lift Gate Spoiler . . . . . . . . . . . . . . . . . . . . . .	. . . . 67
	Door Glass Opening Moulding . . . . . . . . . . . . . .			. 59	Lift Gate Trim	62
	Door Latch			57
		. . . . . . . .	. . . . . . . . . . . . . . . . . . . . .		Lower Quarter Trim Panel	61
	Door Opening Scuff Plates			61
					Lower Tail Panel Trim Cover	62
	Door Opening Weatherstrips			60
					Manual Window Lift Plate and Guide	58
	Door Trim Panel			56
					Manual Window Regulator	57
	Floor Carpet			64
					Manual Window Regulator	58
	Front Center Console			64
					Outside Door Latch Release Handle	58
	Front Door and Hinge			56
					Overhead Console	65
	Front Door Silencer and Water Shield			56
					Power Door Lock Actuator	59
	Front End Splash Shields			54
					Power Window Regulator	57
	Front Fender . . . . . . . . . . . . . . . . . . . . . . . . . . .			. 55
	Front Seat Belts . . . . . . . . . . . . . . . . . . . . . . . . .			. 62	Quarter Glass Module . . . . . . . . . . . . . . . . .	. . . . 66
	Front Seats	. . . . . . .	. . . . . . . . . . . . . . . . . . . . .	. 63	Quarter Panel Spoiler . . . . . . . . . . . . . . . . . .	. . . . 67
	Fuel Fill Door . . . . . . . . . . . . . . . . . . . . . . . . . . .			. 68	Rear Seat Belts . . . . . . . . . . . . . . . . . . . . . .	. . . . 63
	Glass Run Weatherstrip . . . . . . . . . . . . . . . . . . .			. 58	Rear Seats . . . . . . . . . . . . . . . . . . . . . . . . .	. . . . 63
	Head Lining	. . . . . . .	. . . . . . . . . . . . . . . . . . . . .	. 65	Rear Window Glass . . . . . . . . . . . . . . . . . . .	. . . . 65
	Hood and Hinges . . . . . . . . . . . . . . . . . . . . . . . .			. 52	Roof Seam Molding . . . . . . . . . . . . . . . . . . .	. . . . 66
	Hood Applique . . . . . . . . . . . . . . . . . . . . . . . . . .			. 54	Side View Mirror . . . . . . . . . . . . . . . . . . . . .	. . . . 59
	Hood Latch and Release Cable . . . . . . . . . . . . .			. 53	Sunroof Lift Control . . . . . . . . . . . . . . . . . . .	. . . . 65
	Hood Latch Safety Catch . . . . . . . . . . . . . . . . . .			. 54	Tail Lamp Closure Panel . . . . . . . . . . . . . . .	. . . . 69
	Inside Latch Release Handle . . . . . . . . . . . . . . .			. 59	Upper Quarter Trim Panel . . . . . . . . . . . . . .	. . . . 61

CLOSURE PANEL SIGHT SHIELD

REMOVAL (FIG. 1)

(1)Raise hood to open position.

(2)Loosen twist fasteners holding headlamp covers to fascia.

(3)Disengage hook and loop fasteners holding sight shield to radiator closure panel.

(4)Remove push-in fasteners holding sight shield to bumper fascia.

(5)Separate sight shield from vehicle.

INSTALLATION

Reverse the preceding operation.

HOOD AND HINGES

HOOD REMOVAL (FIG. 2)

(1)Raise hood to full up position.

(2)Lift front edge of cowl cover on the right side of the windshield washer bottle and disconnect the under hood lamp wire connector.

(3)Mark all bolt and hinge attachment locations with a grease pencil or other suitable device to provide reference marks for installation. When installing hood, align all marks and secure bolts. The hood should be

Fig. 1 Closure Panel Sight Shield

aligned to 4 mm (0.160 in.) gap to the front fenders and flush across the top surfaces along fenders.

(4)Remove the top hood to hinge attaching bolts and loosen the bottom bolts until they can be removed by hand.

(5)With assistance of a helper at the opposite side of the vehicle to support the hood, remove the bottom hood to hinge attaching bolts. Separate the hood from the vehicle.