Ä

FRONT DOOR REMOVAL (FIG. 14)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Disconnect all wire connectors and wire harness hold downs inside door and push wire harness through access hole in front of door into hinge pillar opening.

(3)Open door and support door on a suitable lifting device.

(4)Drive bottom hinge pin upward and remove pin from hinge.

(5)Drive top hinge pin downward and remove pin from hinge.

FRONT DOOR INSTALLATION

Reverse the preceding operation. The door should not require re-alignment. If door does need alignment, refer to Front Door Hinge Installation paragraph in this section.

Fig. 14 Front Door Assembly

FRONT DOOR HINGE REMOVAL (FIG. 14)

(1)Remove front fender wheelhouse splash shield. Refer to Front Wheelhouse Splash Shield Removal paragraph in this section.

(2)Support door on a suitable lifting device.

(3)Drive out hinge pin on the effected hinge.

(4)Remove bolts holding hinge to hinge pillar and separate hinge form vehicle.

FRONT DOOR HINGE INSTALLATION

Reverse the preceding operation. Align door to achieve 6 mm (0.240 in.) gap to all surrounding panels and flush across gaps.

DOOR LATCH

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield, as necessary.

(3)Raise door glass to up position.

AG-BODY 23 - 57

(4)Disconnect linkage rods from door latch assem-

bly.

(5)Remove screws holding latch top door end frame.

(6)Separate latch from door.

INSTALLATION

Reverse the preceding operation.

MANUAL WINDOW REGULATOR

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Raise glass to 25 mm (1 in.) below full up position and support glass lift plate to keep the glass from falling.

(4)Remove bolts holding regulator to inner door panel.

(5)Slide regulator lift arm roller from lift plate channel.

(6)Remove regulator assembly through access hole in door.

INSTALLATION

Reverse the preceding operation.

POWER WINDOW REGULATOR

REMOVAL (FIG. 15)

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Raise glass to 25 mm (1 in.) below full up position and support glass to keep the glass from falling. Disconnect battery negative cable.

(4)Remove bolts holding regulator to inner door panel.

(5)Remove nuts holding lift plate to glass.

(6)Remove regulator assembly through access hole in door.

INSTALLATION

Reverse the preceding operation.

Fig. 15 Power Window Regulator