23 - 124 AP/27 CONVERTIBLE		Ä

Fig. 33 Quarter Panel Belt Moulding

TRUNK LID LINING

REMOVAL (FIG. 34)

(1)Raise trunk lid.

(2)Remove screws holding trunk lid lining to inside of trunk lid.

(3)Support trunk lid in the full up position.

(4)Disconnect trunk lid prop cylinders.

(5)Separate trunk lid lining from vehicle.

INSTALLATION

Reverse the preceding operation.

Fig. 34 Trunk Lid Lining and Prop Cylinder

TRUNK LID APPLIQUE

REMOVAL (FIG. 35)

(1)Remove trunk lid lining as necessary to gain access to applique attaching nuts.

(2)Remove nuts holding applique to trunk lid.

(3)Separate applique from trunk lid.

(4)Disconnect center high mounted stop lamp wire connector.

(5)Remove applique from vehicle.

INSTALLATION

Apply sealing putty around mounting studs on back of applique and reverse the removal operation.

Fig. 35 Trunk Lid Applique

TRUNK OPENING WEATHERSTRIP

REMOVAL (FIG. 36)

(1)Raise trunk lid.

(2)Pull trunk lid opening weatherstrip from pinch flange around opening.

(3)Separate weatherstrip from vehicle.

INSTALLATION

Position weatherstrip at center of rearward pinch flange. Push weatherstrip onto pinch flange around trunk opening and join the ends of the weatherstrip when they meet.

Fig. 36 Trunk Opening Weatherstrip

TRUNK LID

REMOVAL (FIG. 37)

(1)Raise trunk lid to full up position.

(2)Disconnect the trunk lamp wire connector, if equipped.

(3)Mark all bolt and hinge attachment locations with a grease pencil to provide reference marks for installation. When installing trunk lid, align all