Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

(4)Drive bottom hinge pin upward and remove pin from hinge.

(5)Drive top hinge pin downward and remove pin from hinge.

FRONT DOOR INSTALLATION

Reverse the preceding operation. The door should not require re-alignment. If door does need alignment, refer to Front Door Hinge Installation paragraph in this section.

Fig. 10 Front Door Assembly

FRONT DOOR HINGE REMOVAL (FIG. 10)

(1)Remove front fender wheelhouse splash shield. Refer to Front Wheelhouse Splash Shield Removal paragraph in this section.

(2)Support door on a suitable lifting device.

(3)Drive out hinge pin on the effected hinge.

(4)Remove bolts holding hinge to hinge pillar and separate hinge form vehicle.

FRONT DOOR HINGE INSTALLATION

Reverse the preceding operation. Align door to achieve 6 mm (0.240 in.) gap to all surrounding panels and flush across gaps.

DOOR LATCH

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield, as necessary.

(3)Raise door glass to up position.

(4)Disconnect linkage rods from door latch assem-

bly.

(5)Remove screws holding latch top door end frame.

(6)Separate latch from door.

INSTALLATION

Reverse the preceding operation.

AJ-BODY 23 - 75

WINDOW REGULATOR

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield as necessary.

(3)Raise glass to 25 mm (1 in.) below full up position and support glass lift plate to keep the glass from falling.

(4)Disconnect power window motor wire connector, if equipped.

(5)Remove rivets holding regulator to inner door panel using a 6 mm (0.250 in) drill.

(6)Slide regulator lift arm roller from lift plate channel.

(7)Remove regulator assembly through access hole in door.

INSTALLATION

Reverse the preceding operation.

DOOR GLASS

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield.

(3)Raise door glass 100 mm (4 in.) from down position.

(4)Disconnect battery negative cable if equipped with power windows.

(5)Loosen bolts holding glass stabilizers and guide hook receiver to top of inner door frame.

(6)Remove nuts holding door glass to lift plate.

(7)Separate glass from lift plate and lift glass upward from opening at top of door.

INSTALLATION

Reverse the preceding operation.

DOOR GLASS LIFT PLATE AND GUIDE POST

REMOVAL

(1)Remove door trim panel.

(2)Remove silencer and water shield.

(3)Raise door glass 100 mm (4 in.) from down position.

(4)Disconnect battery negative cable if equipped with power windows.

(5)Remove nuts holding door glass to lift plate and separate glass from lift plate. Allow glass to slide downward to the bottom of door.

(6)Remove bolts (nuts on AJ-27 body) holding guide post to inner door panel.

(7)Separate lift plate channel from regulator lift roller.

(8)Remove lift plate and guide assemble from door through access hole in inner door panel.

INSTALLATION

Reverse the preceding operation.

Соседние файлы в папке FWD