23 - 60 AG-BODY		Ä

Fig. 21 Window Opening Moulding

Fig. 22 Outer Belt Weatherstrip

DOOR OPENING WEATHERSTRIPS

REMOVAL

(1)Remove interior trim as necessary to gain access to door opening weatherstrip.

(2)Pull weatherstrip from pinch flange around door opening.

INSTALLATION

(1)Locate the middle to the weatherstrip at the center of the upper pinch flange. Push weatherstrip onto pinch flange at the top corner near the B-pillar.

(2)When the weatherstrip has been installed down the door opening to the sill pinch flange, mate the ends of the weatherstrip together and finish installing.

BODY SIDE MOULDINGS

STICK-ON BODY SIDE MOULDING REMOVAL AND INSTALLATION

(1)Warm the effected stick-on moulding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.

(2)Pull stick-on moulding from painted surface.

(3)Remove adhesive tape residue from painted surface of vehicle.

(4)If moulding is to be reused, Remove tape residue from moulding. Clean back of moulding with Mopar, Super Kleen solvent or equivalent. Wipe

moulding dry with lint free cloth. Apply new body side moulding (two sided adhesive) tape to back of moulding.

(5)Clean body surface with Mopar, Super Kleen solvent or equivalent. Wipe surface dry with lint free cloth.

(6)Apply a length of masking tape on the body, parallel to the top edge of the moulding to use as a guide, if necessary.

(7)Remove protective cover from tape on back of moulding. Apply moulding to body below the masking tape guide.

(8)Remove masking tape guide and heat body and moulding, refer to step one. Firmly press moulding to body surface to assure adhesion.

BODY SIDE APPLIQUE

REMOVAL (FIG. 23)

DOOR APPLIQUE

(1)Remove rivets holding bottom or door applique to door pinch flange using a 3 mm (0.125 in.) drill.

(2)Lift door applique upward to disengage applique from retainer channel.

(3)Separate applique from door.

SILL APPLIQUE

(1)Remove push-in fasteners holding sill applique to bottom of rocker panel.

(2)Remove push-in fasteners holding sill applique to front and rear wheel lip openings.

(3)Lift sill applique upward to disengage applique from retainer channels.

(4)Separate sill applique from vehicle.

INSTALLATION

Prime and touch-up bare metal surfaces before installing applique to avoid corrosion. Reverse the removal operation.

Fig. 23 Body Side Applique