Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
56
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 130 AY-BODY

HOOD LATCH RELEASE CABLE REMOVAL (FIG. 8)

(1)Raise hood to the full up position.

(2)Remove push-in fasteners holding hood latch cover to radiator closure panel and separate cover from vehicle.

(3)Disconnect hood release cable casing and cable end from hood latch assembly. Refer to Hood Latch Removal procedure in this section.

(4)Remove hood latch release cable handle attaching bolts from under left lower edge of instrument panel.

(5)Disengage release cable rubber grommet from engine compartment dash panel behind instrument panel.

(6)Rout cable assembly through engine compartment around battery, under fender lip, under relay bank, and under wiring harnesses, toward dash panel. Push cable through access hole in dash panel under the brake master cylinder, into passenger compartment.

HOOD LATCH RELEASE CABLE

INSTALLATION

Reverse the preceding operation.

Fig. 8 Hood Latch Release CableÐTypical

FRONT END SPLASH SHIELDS

FRONT WHEELHOUSE SPLASH SHIELD REMOVAL (FIG. 9)

(1)Hoist vehicle and support on suitable safety stands.

(2)Remove front wheel assembly.

(3)Remove push-in fasteners holding front wheelhouse splash shield to fender opening lip and inner wheelhouse area.

(4)Separate wheelhouse splash shield from vehicle.

Ä

FRONT WHEELHOUSE SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

TRANSAXLE SPLASH SHIELD REMOVAL (FIG. 9)

(1)Remove one front wheelhouse splash shield push-in fastener and separate wheelhouse splash shield from transaxle splash shield.

(2)Remove transaxle splash shield attaching bolts and separate transaxle splash shield from vehicle.

TRANSAXLE SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

Fig. 9 Front Wheelhouse and Transaxle Splash

Shields

ENGINE DRIVE BELT SPLASH SHIELD REMOVAL (FIG. 10)

(1)Hoist vehicle and support on suitable safety stands.

(2)Remove bolts holding engine drive belt splash shield to right frame rail.

(3)Separate drive belt splash shield from vehicle.

ENGINE DRIVE BELT SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

FRONT DOOR TRIM PANEL

TRIM PANEL REMOVAL (FIG. 11)

(1)Disengage frog-leg fasteners holding power seat switch/speaker bezel to door trim. Separate bezel from trim panel.

(2)Disconnect power seat switch wire connector.

(3)Remove screws holding trim panel to door from around speaker and power seat switch.

(4)Remove screws holding pull handle to door trim and separate pull handle from door.

(5)Remove hidden screws holding trim panel to inner door panel from behind carpet insert.

Соседние файлы в папке FWD