23 - 106 AP-BODY		Ä

cover. Remove bolt holding turning loop to roof panel.

(2)Remove quarter trim panel, lower panel on AP-

44.

(3)Remove bolt holding lap belt to floor at wheelhouse kickup.

(4)Remove bolt holding seat belt retractor to quarter panel.

REAR SHOULDER HARNESS/LAP BELT INSTALLATION

Reverse the preceding operation.

REAR INBOARD BUCKLE/CENTER OCCUPANT BELTS REMOVAL (FIG. 34)

(1)Remove rear seat cushion.

(2)Remove bolt holding inboard buckle/center occupant belt to floor.

(3)Separate buckle/belt assembly from vehicle.

REAR INBOARD BUCKLE/CENTER OCCUPANT BELT INSTALLATION

Reverse the preceding operation.

Fig. 34 Rear Seat BeltsÐTypical

FRONT SEATS

REMOVAL (FIG. 35 OR 36)

(1)Position seat full forward.

(2)Remove screws holding rear track riser covers and separate covers from tracks.

(3)On power seat track, remove outboard track

cover.

(4)Remove nuts holding seat track to floor.

(5)Position seat full rearward.

(6)On power seat track, remove door sill scuff plate and disconnect wire connector.

(7)Remove bolts holding seat track to cross mem-

ber.

(8)Remove seat from vehicle.

INSTALLATION

Reverse the preceding operation.

Fig. 35 Manual Front Seat

Fig. 36 Power Front Seat

REAR SEATS

REAR SEAT CUSHION REMOVAL

(1)Remove bolts holding cushion to floor.

(2)Push center occupant seat belts through openings in cushion.

(3)Remove cushion from vehicle.

REAR SEAT CUSHION INSTALLATION

Reverse the preceding operation.

REAR SEAT BACK REMOVAL (FIG. 37)

(1)Hinge seat back forward and disengage push-in fasteners holding carpet backing to trunk floor.

(2)Remove bolts holding outboard hinge pivot bracket to seat back.

(3)Pull seat back outward to disengage inboard pivot and separate from vehicle.