23 - 98 AP-BODY

MANUAL WINDOW REGULATOR

INSTALLATION

Reverse the preceding operation.

Fig. 17 Front Door Manual Window

RegulatorÐTypical

FRONT DOOR WINDOW REGULATOR/POWER

POWER WINDOW REGULATOR REMOVAL (FIG. 18)

(1)Remove trim panel and water shield and connect window switch to wire connector.

(2)Raise glass to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.

(3)Disconnect battery negative cable.

(4)Remove bolts holding window regulator to inner door panel.

(5)Slide roller from window lift channel. Rotate regulator

to bring lift arm through access hole first.

(6)Remove regulator assembly from door.

POWER WINDOW REGULATOR INSTALLATION

Reverse the preceding operation.

REAR DOOR TRIM PANEL

REMOVAL (FIG. 19)

(1)Move glass to down position.

(2)Disconnect battery negative cable.

(3)Remove inside latch release handle bezel. Pull outward at forward edge and push bezel rearward.

(4)Remove screw cover from window crane. Remove screw holding crank to window regulator, if equipped.

(5)Remove screw covers from armrest. Remove screws holding armrest to door.

(6)Disengage frog-leg clips holding trim panel to door. Separate trim panel from door.

(7)Disconnect courtesy lamp wire connector.

Ä

Fig. 18 Front Door Power Window

RegulatorÐTypical

INSTALLATION

Reverse the preceding operation.

Fig. 19 Rear Door Trim Panel

REAR DOOR SILENCER AND WATER SHIELD

REMOVAL (FIG. 20)

(1)Remove door trim panel.

(2)Pull water shield from adhesive around perimeter of door inner panel.

INSTALLATION

Reverse the preceding operation.

REAR DOOR AND HINGE

The rear door hinge is welded to the door and bolted to the B-pillar. The door half of the hinge pivots on a removable hinge pin. The hinge pin is driven in from the bottom on the top hinge and from the top on the bottom hinge. All adjustments to the hinge are performed on the hinge pillar half of the hinge. If the welded half of the hinge must be bent to align door, consult an authorized body repair facility.